Posts Tagged ‘Covington’

Is Your Furnace Making too Much Noise? A Question from Villa Hills

Monday, October 24th, 2011

The old saying that “It is better to be seen than heard” certainly applies to the mechanical equipment in your Villa Hills home. If you hear a squeaky noise or loud clattering you automatically suspect that something is wrong. And if that noise is coming from your furnace, you better pay attention to it. A noise is an obvious sign of a problem – minor or major – and it could result in mechanical failure that could leave your home cold and uncomfortable – and affect your home’s indoor air quality.

Today’s newer variable-speed furnaces keep a constant airflow through the ventilation system utilizing a low speed fan that consumes small amounts of electricity. Constant airflow brings in fresh air and keeps the room air from becoming stale or stagnant. Because of this constant operation, it is important to ensure the furnace is running at peak efficiency, which also means that it is running quietly.

Here are some common noises, possible reasons, and suggested repairs. As always, if you are in doubt about how to repair your furnace, call a local qualified heating contractor and schedule a service call.

Squealing noise – could be a worn out or slipping blower belt. Check for proper tension of the belt or replace the belt if it is worn out or cracked.

  • Squealing noise – could be worn out motor shaft bearings. Lubricate the blower motor at the proper points.
  • Rumbling noise – often caused by a poorly adjusted pilot light when the burners are turned off. Adjust the pilot as necessary.
  • Rumbling noise – often caused by dirty gas burners when the burners are switched on. This problem requires service from a qualified heating technician.
  • Buzzing noise – often caused when a blower motor mounting come loose. Tighten the mounting screws or use shims to fill gaps.
  • Hissing noise – indicates a possible air leak. This problem requires service from a qualified heating technician.
  • Ticking noise – possibly a leaky gas valve. This problem requires service from a qualified heating technician.
  • Rattling noise – could be a dirty fan blade. Wipe the fan blade or clean with degreaser.
  • Rattling, grinding, or whining – could be resistance to airflow that causes the motor to work harder. Check the vents in each room for dirt, debris, or obstructions and clear them.
  • Vibrating noise – may not be the furnace but loose or cracked seams in the ventilation system. Check the ductwork seams and hangers to ensure everything is tight. You may need duct tape or bracket hardware.

The best way to keep your furnace and ventilation system from making noises is to practice preventative maintenance. Have your furnace checked annually by a qualified heating contractor – and enjoy the peace and quiet.

Tags: , , , , , ,
Posted in Services | Comments Off

Maintenance Tips From Villa Hills: Why You Should Have Your Furnace Serviced Every Heating Season

Wednesday, September 28th, 2011

Particularly if you’ve just purchased a new furnace in Villa Hills, it’s probably not something you think about all that much. As long as it works when you need it to, that is. Unfortunately you usually find out that something is wrong with your furnace just when you need it most. However, there is a way to avoid that kind of problem, and many others, and that’s to have regular maintenance service performed on your furnace by a home heating professional every year.

One of the main reasons to have your furnace serviced is that it allows technicians to catch small problems before they become large ones. During a typical maintenance visit, a technician will examine all parts of your furnace to ensure that they are still in good working order. He’ll also thoroughly clean out the unit to make sure there are no buildups of debris that could cause problems or impede the furnace’s energy efficiency.

And if they do find something wrong like a part that’s beginning to wear out or something that just isn’t working properly, the technician can make the necessary repairs right away. You can get the problem taken care of ahead of time and you won’t have to worry about going without heat during the coldest part of the winter.

That’s not the only reason that annual maintenance is important and beneficial, however. It can also help you save money, both on your monthly energy bills and in the long term. That’s because annual maintenance tune ups keep your furnace functioning at peak efficiency levels longer than they would be able to otherwise.

A typical furnace will lose a small percentage of its energy efficiency every year, and while it won’t seem like a lot at first, that can really add up over the course of a couple of years. With regular maintenance, though, you can often maintain up to 95% of your furnace’s original efficiency for the life of the furnace.

Plus, when the proper maintenance and service is performed on a regular basis, your furnace will simply last longer.

Tags: , , , , ,
Posted in Services | Comments Off

What Is Geothermal Heating? A Question From Villa Hills

Monday, September 12th, 2011

Having a geothermal heating system installed in your Villa Hills home means that you will actually be able to heat your home with heat extracted from the ground. If this sounds a bit preposterous to you, you are certainly not alone. But this type of home heating does actually work and the technology is not actually that much different from what is used in a standard heat pump system.

Regular heat pumps are able to remove heat from the outdoor air and transfer it into your house to maintain a comfortable temperature in the winter. You may think that there is no heat in the outdoor air in the winter, but that is not actually the case.

Air contains a substantial amount of heat even at very cold temperatures, and heat pumps are able to work quite well, particularly when the outdoor temperature is above freezing. Conveniently, the same process used to heat your house in the winter can be reversed in the summer to extract heat from the indoor air, providing you with a year round home comfort solution.

Geothermal heating works in much the same way, except that geothermal heat pumps extract heat from the ground rather than the air. In order to accomplish this, a loop of pipes is installed in the ground near your house and your geothermal heating system will pump a liquid, generally either antifreeze or water, through those pipes.

As it passes through the pipes, the liquid will absorb heat from the ground and carry it back to a heat exchanger within your house. At that point, the heat from the liquid will be released into air, which is then blown throughout your house.

And just as conventional heat pumps can cool your house in the summer by removing heat and pumping it outside, so too can geothermal heating systems. They do this simply by letting the liquid flowing through the pipes absorb the heat from inside air and then release it into the ground as it travels through the pipe loop below your house.

Because the ground is never as cold in the winter or as hot in the summer as the air, geothermal heat pumps are actually able to work effectively in more extreme conditions than many traditional heat pumps. However, because they require an entire system of pipes to be installed underground, they can be quite a bit more expensive initially as well.

Tags: , , , ,
Posted in Services | Comments Off

Different Types of Refrigerants Used in HVAC: A Guide From Covington

Friday, September 9th, 2011

We have all heard the phrases in Covington like “save the planet” or “save the ozone layer.” Up until the 1960s there wasn’t a lot of attention paid to the disintegrating protective ozone layer around the Earth’s surface. Since then, ozone-depleting CFCs (chlorofluorocarbons) have been seen as the ozone-depleting culprit and new laws regulating the use of CFCs have had a direct impact on heating and cooling (HVAC) systems.

The “lifeblood” of any air conditioning and heat pump system is its refrigerants – a chemical used in the refrigeration cycle. For several decades, the “refrigerant of choice” in HVAC systems has been HCFC-22, also known as R-22. The problem is, HCFCs (hydrochlorofluorocarbons) are harmful to the ozone layer because they contain ozone-destroying chlorine.

Because of this, the use of R-22 is being slowly phased out from usage in HVAC systems. The Clean Air Act of 1970 has provisions in it to phase out HCFC refrigerants. As a result, chemical manufacturers will no longer be able to produce, and companies will no longer be able to import, R-22 for use in new air conditioning equipment (effective this year),  but they can continue production and import of R-22 until 2020 for use in servicing existing equipment. So, R-22 should continue to be available for all systems that require R-22 for servicing for many years to come.

But the “new kid on the block” replacing R-22 has been getting up a head of steam for several years now. Among the new alternative refrigerants recommended by the U.S. EPA is R-410A, a blend of hydrofluorocarbons (HFCs) that does not contribute to depletion of the ozone layer, but, like R-22, contributes to global warming. R-410A is manufactured and sold under various trade names, including GENETRON AZ-20®, SUVA 410A®, Forane® 410A, and Puron®.

There are several other substitute refrigerants going by the names of R-407C, HFC-134A, and R-422C. A complete list can be found at www.epa.gov.

According to the U.S. EPA, homeowners with existing units using R-22 can continue to use R-22 since there is “no requirement to change or convert R-22 units for use with a non-ozone-depleting substitute refrigerant.” And it is important to note that R-407C is allowed for retrofits but R-410A is not, due to its higher working pressures. Substitute refrigerants would not work well with existing components unless a retrofit was made or in the case of using R-410A, a complete system changeout.

One of the leading causes for air conditioner and heat pump failure are lower levels of refrigerant. If you are working on your own equipment, it is important to note that replacing refrigerants like R-22 and R-410A should only be done by certified HVAC professionals. You must show EPA certification to purchase these refrigerants.

If you are interested in “saving the planet” you might do well to give the boot to your HCFC-consuming appliance.

Tags: , , , , , ,
Posted in Services | Comments Off

Portable Air Conditioners

Wednesday, July 20th, 2011

If you’re in the market for an air conditioner, you’re probably familiar with central and window air conditioning units. But did you know there was another option? While they’re not perfect for every situation, portable air conditioners can provide reliable, even cooling for many homes.

Advantages of Portable Units

Of course, the main reason to buy a portable air conditioner is that it’s, well, portable. With one of these units, you don’t have to worry about which room to put the air conditioner in. Instead, you can simply take it with you wherever you go in the house.

Many people like to keep a portable air conditioner in their bedroom to take the edge off at night without dropping the temperature as much as a window unit might. And most portable air conditioners are quieter to operate than common window units. Portable air conditioners also come in a wide variety of sizes, so you can easily find one that matches your needs.

Disadvantages of Portable Units

Unlike window air conditioners that are automatically installed to vent and drain outside of a building, a portable air conditioner requires special setup. That means that every time you move your unit, you’ll have to find somewhere to place the exhaust hose so that fumes don’t accumulate in the room. This also means that portable air conditioners can’t be used in rooms without access to windows or air vents.

The cooling power of most portable air conditioners is not quite on par with equivalent window units either. You’ll want to choose a portable unit with slightly more BTUs than if you were buying a window unit to take care of the same sized room. As a result, the portable unit may cost slightly more to operate during peak cooling months.

Extras to Look For

Of course, while the cost may go up slightly, there are a lot of benefits to owning a portable air conditioner. For instance, many portable air conditioners can be used independently to dehumidify a room without cooling. This is often helpful (and can save energy) when the temperature would be bearable if not for the humidity level.

You also want to make sure that your portable air conditioner really is portable. That means finding a model with wheels and handles or some other mechanism that makes it easy to move it from place to place.

Tags: , , ,
Posted in Services | Comments Off

How a Thermostat Works

Monday, July 4th, 2011

Your thermostat is designed to closely monitor and maintain the temperature in your home. When you flip the switch, you want your furnace or air conditioner to respond immediately. So, it’s a good idea to learn how it works so that if there is a problem, not only will you know better what needs to be fixed – you can decide whether to call a professional in for help.

Thermostats shouldn’t need input from you other than to set the initial temperature. From there, they are automatic switches. A thermometer inside the thermostat measures the indoor air temperature. When it gets above or below the limit you’ve specified, it triggers the thermostat to send a message to your home comfort system and keep things nice and comfortable.

Types of Thermostats

Thermostats come in two forms –electromechanical and electronic. An electromechanical thermostat is the simplest and has been used for decades to regulate temperature in homes. It has a simple strip or coil of metal that expands as the temperature rises and contract as it lowers. A mercury thermometer is placed on top of the strip. The coil’s movements cause the vial to tip as the temperature changes. There is a pair of electrical contacts on either end of the vial. The mercury can absorb that electrical current when the electrical contacts touch the thermometer. The mercury then acts as a switch to turn on your comfort system.

An electronic thermostat simply has an electronic sensor that measures the indoor air temperature. You set a temperature for your room and when it changes significantly, the switch inside your electronic thermostat is triggered, causing it to turn on your comfort system.

Ways to Upgrade Your Thermostat

Most homes only need the bare minimum in their thermostats. However, there is some very exciting technology on the market these days that can add quite a bit of value to your system. Not only can you install a programmable thermostat, you can opt for zone control systems that allow multiple thermostats in different rooms of your home.

Programming allows you to set temperatures for certain times of the day. This is especially great if you are gone from the house for long periods of time each day. Why heat or cool a home when it is empty? And if you have multiple people with different temperature needs, zone control temperature control allows you to set specific temperatures for specific rooms in your home – a very enticing option for large families or multi-story homes.

Tags: , , , ,
Posted in Services | Comments Off